where can you get one?
I am talking about the one you stick inline of the coolant hose and it has a gauge on it
where can you get one?
I am talking about the one you stick inline of the coolant hose and it has a gauge on it
2010 Honda CBR1000RR Orange/Silver. New toy
2005 Honda TRX450R .. was fun..
Hmmm.... DFR.![]()
Jeremy
06 TRX450ER
08 TRX450ER
08 CRF450 #46
Newport Beach Orange County Web Design
Online Pick-N-Pull
ESR has a nice one
Whiplash #121
05 Honda TRX450r
2010 Sponsors: DFR, Laker Custom, Steel Mx, Fasst Co, Pro Armor, 661, DWT
Brent waste of money
2010 Sponsors
Phillips Trenching
Fox Shocks
Quad Tech
Scott Goggles
DWT
It may be. but right now the quad seems to be running a little hot.
the fan turns on but i have no specs on when it should. Nick says his can idle for around 10-15 mins before it turns on. I think mine is around 5 mins. and the fan turns on.. It seemed to run a little hot at Canyon today. ( nick thinks so) i never noticed the little red light on while i was riding.
2010 Honda CBR1000RR Orange/Silver. New toy
2005 Honda TRX450R .. was fun..
If you do get one make sure to put it on the correct hose, which is the top hose.
I run an ESR inline gauge.
Jeremy
06 TRX450ER
08 TRX450ER
08 CRF450 #46
Newport Beach Orange County Web Design
Online Pick-N-Pull
I don't remember what mine runs at. Been a while since its been up to operating temp!
Seems like I remember 170-175ish
Jeremy
06 TRX450ER
08 TRX450ER
08 CRF450 #46
Newport Beach Orange County Web Design
Online Pick-N-Pull
The manual should tell what the on/off temps are for the fan switch.
It can be tested by pulling it and throwing it in a pan of water, put it on the stove and watch the water temp. With an ohm meter across the switch leads it should show open, (infinity) it will close when it reaches it's 'ON-trip temp'. Turn off the heat and slowly add colder water to the pan to help it cool down a bit quicker. Go slow & stir or you'll miss the off-temp & need to start over. The 'off-trip temp' should be lower then the 'on-trip temp.
Does the fan cycle on and off at all? During idle AND/or riding?
Temp probe placement depends on what temp you want to read. If you want to read the coolest anti freeze temp entering the engine put it in the 'coolant supply' to the engine. If you want to see the highest antifreeze temp of the engine, put it in the 'coolant return' from the engine.