ltr 450 motor problem

[Dillon 17]

So here is the story, I don;t know whats wrong. I had to rebuild my motor because it blew up at the dunes. I put it back together and the cam locked up in the head before I even rode it down the street. I bought a brand new head and put it back together for the second time and started it up. after it started I drained the oil and found out that there was coolant leaking into my oil. Rudy at dfr said that my head gasket probably wasnt sealing right so I took it apart for a third time and put it back together with brand new gaskets again this morning and it started, but the oil is filled with water again

Does anyone have any idea what could be going on? Ive tried everything I can think of.

[Phillips#89]

Need to sell it and buy a honda

[quadcrazy]

water pump seals???

[brent701]

The right case has a seal/gasket that seals the oil/coolant from each other. lt me see if i can get a pic right fast from one of my dead engines

[brent701]

Ok, This is the right Case gasket. I am pointing the screw driver in between the Coolant(left round hole) and the Oil (Right long hole). If You had the case apart. that could be it. Or it may be bad.

[brent701]

Need to sell it and buy a honda

Or do what he said

[Dillon 17]

Need to sell it and buy a honda

Thats what I'm going to do but i need to get this running so I can sell it

[Dillon 17]

I guess I'll just replace the water pump seals and that gasket to make sure I get this problem straightened out. I've had this thing apart and put back together three times already on this build.