FCI fit in airbox?

[rinehart_mitch]

Hi, i have the opprotunity to get a Fuel customs intake kit...cheap, and i know i have seen them out of airboxes, but will they fit in the box with a little modding or little to none at all? I have a buch of holes in the sides of it already so it can breath but i dont want it to just be out there in the open for a few reasons, thanks for the replys in advance!

[Bowtie]

I don't know on the TRX, but I had mine in a modded box on the YFZ. If your fab skills are good, I am sure you can do it.

[ElderGeek]

Mine fit, but it was tight with the 8 ply filter. I ended up cutting the back of the airbox out to make it easier to remove/replace the filter. I did not use the 'ring' that came with intake. Added some window seal to make a sudo gasket to seal around the front of the intake. I drilled some holes on the left side but none on the exhaust side. I would need to duct tape some of it up if I were to run in alot of mud and water.

This is on a YFZ.

[Bowtie]

Hey!!! Some of that looks familiar!!!

[ElderGeek]

The intake should.

I was going to post a pic of your Fab Skills.... But I didn't want to embarrass you....

[Bowtie]

The intake should.

I was going to post a pic of your Fab Skills.... But I didn't want to embarase you....

HA HA HA .......... HA and look who stole my ideas!!!! LMAO!!!!!!!



and its embarrass

[ElderGeek]

Not so much stole, rather plagiarized and improved...

[Bowtie]

Not so much stole, rather plagiarized and improved...

[rinehart_mitch]

ok thanks, i am still waiting for the dude to message me back. I am not to worried out mud and water cause my air box looks like swiss chees, until you look at the bottom, thats solid i have no problem cuttin some peices out...

[Jeremy]

Yes it can fit in the box.