My engine woes...

[Prednizone]

For those following...

Link to trx450r.org thread about my engine woes

[quadcrazy]

Man those pics tell a story!

[Jimmy4765]

Wow man! That blows! Maybe you can Flitz it?!!!

[Coondog #77]

wow thats intense! i hope i never see something like this on my bike. nothing looks worse than pulverised metal.

[trx450r64]

I have done this a few times but in mine the cases were way more scratched and banged up.It sucks when this happens.

[lwrider20]

ya that really sucks. im in the same boat right now, my hotrod crank bearing went out and took out most of the motor. looks like i need a new left side case, cylinder, piston, crank, rod, oil pump and whatever else pops up. sucky thing is that this was my fresh racer's edge built motor that had maybe an hour on it. wasnt there fault at all just another bad crank from hot rod.

[06YFZ45racer]

That sucks dude!!! That is REALLY ugly..

If you need any help let me know and if I can make it out there you know i will!

[Jeremy]

I've got a complete bottom end that has a toasted transmission and needs a new crank. If you want it, I'll sell it to you cheap to hopefully you get back on the dirt sooner than August.

[Prednizone]

Thanks. But $ is the hold-up till July 31st. That's it. I think I can save the cases, and without the transmission and crank, isn't that all a bottom-end is? If it's cheap enough though...

[Jeremy]

From the amount of shavings in your bottom end I figured that just about every bearing and seal down there would be junked. If that were the case you'd be better off with different cases.

If $ is the issue I can wait until July 31 for you to pay me if you needed this.